AUSTRALIAN MADE

Australian safety compliance approval N11384

• Inexpensive to run
• 30 Watts.. 220-240volt
• Heating length ...900mm

The home brew wrap around electric heater fits around your standard 15-25 litre  brewing fermenter to provide steady constant warmth.

To fit: Place the belt around the outside of the fermenter approximately 45mm from the bottom and adjust it to fit by tightening the mains lead via the hole in outer end of the belt. Do not over tighten, twist, tie or fasten the heater in any other way. Connect the power supply after fitting.

To clean spillage off your heater disconnect power supply and wipe dry.   Do not use heater again until it is completely dry.

When air temperature exceeds 20C  shift the heater up to approximately 150mm from the bottom and when the ambient temperature exceeds 24C switch the heater off. This action should keep the brew at 20-26C depending on ambient temperature.

Can be placed in a heat box (e.g fridge turned off) to warm the surrounding space. 

Can be teamed with a thermostat control to switch on and off to maintain a set temperature.

WARNING: Do not insulate or overheating of belt will occur.